*SOLD* Dust Collector - Aget 15HP - REF# 1653BM
This 15HP dust collector was used right up until it was disconnected in July, 2017. The previous owner needed more cfm with his company growth. The separator was set up outside on a frame and dumped into a bin. The filter unit is set up inside. Most of the dust is collected outside and the extra fine dust is collected inside with the filter unit.
High efficiency design,
Heavy-duty industrial grade construction,
Spark-resistant aluminum alloy fan wheel on direct drive units,
Bolt-together cyclone construction for easy part replacement,
Structural steel unit frame and support stand,
Powder coated finish.
What are the benefits of a cyclone dust collector?
A cyclone dust collector separates and disposes of nearly all large particles from the exhaust before the air stream is sent through a second-stage filter or returned to the environment.
Cyclone collectors are low in cost, require little or no maintenance, and effectively collect most particles over 10 microns in size, allowing less material to be sent to a second stage collector.
In a pull-through cyclone collector design, the large particles are separated out before the fan wheel, allowing AGET to design for maximum airflow without worrying about the fan’s ability to withstand the impact and abrasion of debris.
The cyclone separator is the most efficient dust collector for its cost. REF# 1653BM
Located in Ontario at our Uxbridge Warehouse 20min E of 404 on Davis Drive.
Reference Number: 1653BM
Category: Dust Collector
Location: Ontario, Our warehouse » View On Map
Electrics: 575 V / 3 Ph / 60 Hz
Condition: Very Good
- 15 hp blower,
- 40 filters bags,
- each bag is 6" x 88",
- filter unit with bags is 10 ft high x 32" x 50",
- 12 inch inlet,
To purchase this item or for more information, please contact us.